«

»

Mar 30 2009

Monitor Glass Support

I uesd my tablesaw to dado out an angled groove in a block of wood to support the tinted safety glass in front of the monitor.  I then used glue and pocket hole screws to fasten the block to the inside of the control panel.  This block will not be visible as the control panel will be angled and close over it flush against the glass.

About the author

Dave

Leave a Reply

Your email address will not be published. Required fields are marked *

You may use these HTML tags and attributes: <a href="" title=""> <abbr title=""> <acronym title=""> <b> <blockquote cite=""> <cite> <code> <del datetime=""> <em> <i> <q cite=""> <s> <strike> <strong>